Rad installation steps

Note: See Optional Additional Software for more information about optional features. Category : Berlin. Navigation menu Personal tools Log in. Namespaces Page Discussion. Views Read View source View history. RAD Studio Assistance Recent changes. This page was last edited on 12 October , at After you remove RAD Studio, each user who is not the Administrator must remove user-specific data from the Windows registry:. After you remove RAD Studio, user-specific data such as default project settings might remain in configuration files.

You should manually remove these folders:. From RAD Studio. Jump to: navigation , search. To do this, we recommend using the GetItCmd.

Tip: You can run different versions of the Platform Assistant simultaneously on the same system as long as you use a different port number for each instance. Add a comment. Add Comment Cancel. Step 2 Remove screws and panel at end of footwell. Step 3 Remove access panel in foot well. Step 4 Remove sill panel screw under floor.

Step 5 Remove sill panel tabs. Step 6 Remove and set aside sill panel. Step 7 Locate CAN distribution block. Step 8 Begin CAN plug test.

Step 9 Locate CAN plug. Step 10 Connect T-harness plug into distribution block. Step 11 Connect male connector from OEM plug. Step 12 Insulate connection and replace distribution block. Step 13 Connect ground.

Step 14 Connect power. Step 16 Test operation. Step 17 Mount module and reassemble. Almost done!